The Shaft ain't loading the #3 Pressure Point until there's a Swivel.
Just reading this , been away for a while , they just let me out.
This is an interesting topic. Thanks Bucket.
D, that would imply there's no lag loading when you're putting , I think. Radial acceleration without any Longitudinal.
Im thinking that in terms of Loading, you've got different directions of Loading, which load the #3 at it's different locations. Radial along the aft of the shaft, longitudinal along the top. Which would be the knuckle vs the first joint IF you have a grip that is aligned with the knuckle on the Top of the shaft and the first joint on the AFt of the shaft. Otherwise you're loading against whatever it is you have aligned to the aft and/or top of the shaft. Like my cross handed buddy for instance ........he got lag but not in his right hand.
Remember also that its the lowest connection to the grip that defines the Longitudinal Centre Of Gravity , the Sweetspot Plane ........ My buddies lowest digit is his left index finger but Id imagine he feels lag on the inside of his left fingers ........and /or against the knuckle under his left hand thumb.......for any longitudinal acceleration from Top. But I dunno, it sort a looks like a bowl of speghetti or something.
NO WAY MANG . . . loading don't require swivel . . .
REPHRASE:. . . . Does the Right Elbow Alignment REQUIRE a particular Hinge Motion assuming Rhythm has not been disturbed?
Loading the Secondary Lever requires a Swivel. The Secondary Lever Simultaneously "Loads on the Plane of the Left Wrist Cock" while Maintaining the Geometry of the Right Forearm Flying Wedge and "Loads On-Plane" (Swing-Plane).
Your Second question is still a little fuzzy. Should my answer include every possible scenario including "Manipulating Hands Players" or "Standard-Inherent Only Hinging"?
Loading the Secondary Lever requires a Swivel. The Secondary Lever Simultaneously "Loads on the Plane of the Left Wrist Cock" while Maintaining the Geometry of the Right Forearm Flying Wedge and "Loads On-Plane" (Swing-Plane).
Your Second question is still a little fuzzy. Should my answer include every possible scenario including "Manipulating Hands Players" or "Standard-Inherent Only Hinging"?
Ok I'll agree with you there . . . I thought you were talking Loading "general" . . . witcha . . .
On number 2 . . . sure why not . . . include the whole dealie.
Ok I'll agree with you there . . . I thought you were talking Loading "general" . . . witcha . . .
On number 2 . . . sure why not . . . include the whole dealie.
By "The Book":
Quote:
2-G HINGE MOTION ......These motions actually duplicate the three possible hinge mountings – horizontal, vertical and angled – representing all three Basic Planes (7-5). The Hands can be educated to reproduce them by holding at least one Hand vertical or parallel to the corresponding Basic Plane. These motions also duplicate the motions of paddles of a paddlewheel rotating around its axis vertical to one of the three Basic Planes. And an equivalent could be “Clubface Paddlewheel Action” executed as a Left Wrist Paddlewheel Motion. Thus, though some procedures may cause the Clubface to “Close” in relation to the Plane Line, none will be an actual “Roll” of the Hands. See 2-C and 6-B-3-0.
So.......True "Drive-Out" produced by a Pure Punch Elbow Location (not the one O.b. Left executes), aligns the Right Forearm Wedge so that the Right Hand Rotates around its Axis Vertical to the Angled Plane.
True "Throw-out" produced by the Infallible and Artistically Applied Pitched Elbow Location (in Innercityteachers Dreams), Aligns the Right Forearm Wedge so that the Right Hand Rotates around its Axis Vertical to the Horizontal Plane.
"Off the Record":
"Grip it and Rip it". There is enough "Tolerance" that the Hands (educated) can override the Inherently produced Hinging of "Drive-Out" or "Throw-Out". Especially with Drive-Out on Flatter Planes, the Hitter is more able to produce Horizontal Hinging (especially longer Clubs); and Throw-Out on Steeper Planes, the Swinger is more able to produce Angled Hinging (especially with shorter Clubs). This is very good fortune, especially for the disadvantaged Hitter to aptly produce Horizontal Hinging for longer clubs so that he no longer is called a "short Smacker" or whatever term Ted calls them.
Linear Mode
