This is a single shift not a zero shift. Slide 2 shows the address with the shaft on the elbow plane and when you go to slide 3 the shaft shifts to the turned shoulder plane. Please if you get a chance change slide 2 and have the stick man not bent over from the waist as much and put the shaft on the turned shoulder plane. Then you will have a zero shift. I use this pattern for the Hammer Swing and would like to make an animated gif of the stick man if that is ok. Thanks John W Rohan-Weaver G.S.E.M.

Start Up
 

If Start Up for this hitting stickman with zero shift was from the Standard Address position instead of Impact would the model be 10-6-B #1 and 10-13-D#1?

DRW

I would like to see these stickman photo's but everytime I click on one it gives me an "oops, this link is broken" message. Is there another way to view them?
thanks,
Jim

I have no idea how to upload to this site but I created a slideshow PDF of the Hitting Stickman and can be found here:

https://docs.google.com/fileview?id=...YTdiMzdm&hl=en

ha...funny, should have looked in the swinging stickman thread first, I just wanted something I could flip through easier than all these images, those animated stickman are great!

I'm not advanced, so I'll just ask: Which ones are hitters and swingers?

On Slide 5, the clubface is still facing the ball (close position), but in slide 6 it is parallel with the plane line. How can this be done, by rotating the forearm or fanning?

It just keeps opening at the same rate. Hint: think "simultaneous".

No Stickman Images
 

I guess that I'm 7yrs. too late... but I can't pull up any of the StickMan images. All I get is *404 File Not Found*. Am I the only one? Is it a problem on my end, or are the images no longer available?

same here.

The 404 is fixed.