[12 piece bucket]

I think this is a great idea. I'll throw out two that cause me thought:

Define "alignments".

Good question . . .

ALIGNMENT-The process of adjusting parts so that they are in proper relative position.

Here's a list that isn't all encompassing . . . we can go into further detail.

LEVEL
FLAT
PARALLEL
ON-PLANE
OFF-PLANE
IN-THE-PLANE-OF
DOWN PLANE
PERPENDICULAR
VERTICAL
RADIAL
RADIUS
ARC
CHORD
CIRCUMFERENCE
TANGENT
RAY
RIGHT ANGLES (90 degrees) TO
POINTING ALONG
45 DEGREES ACROSS
VERTICAL
HORIZONTAL
ANGLED
INCLINED
FLAT
BENT
ARCHED
COCKED
UNCOCKED
VERTICAL
TURNED
ROLLED
SWIVEL
FULLY EXTENDED
AHEAD OF
BELOW
PALM FACING
PALM FACING AWAY
AFT
LEANING
ON-LINE
CROSS-LINE
PUSH
PULL