First of all the question is quite vague and perhaps incomplete...
but here's a college try...the #3 accumulator and it's corresponding pressure point is loaded per selected plane angle and per 7-19 procedure..in other words less turn/roll for the turning shoulder plane..more turn/roll for the elbow plane and more for the hands only plane...Now IMO opinion the corresponding pressure point for each accumulator is what is actually loaded ..not the accumulator...So in this case the the right forefinger and it's location side for hitting and top knuckle per swinging is what is loaded....the pressure increases on the pressure pointwith changes of direction and or changes of acceleration during Start down and varies during the release roll for the swinger and increases on the aft side with direct drive of the #1 Pressure Point and indirect drive for the hitter...
So the question shouldn't read..."When accumulator 3 is fully loaded - what is the relation between its plane relative to the inclined plane?"
But rather... "When the #3 Pressure Point is fully loaded- what is it's relation between it's plane relative to the Inclined Plane?...Hell it's different for hitters and swingers...Different for the Hands Only,Elbow Plane,Turned Shoulder and the Turning Shoulder Plane...
Remember very easy concept..
Pressure points are what get loaded...Accumulators are what gather...
Last edited by annikan skywalker : 08-26-2006 at 03:51 PM.
Hybrid Mode
