I don't have the book at hand for reference (shame!) but I believe 12-2 recommends Assembly point for Swingers as End. What advantages are offered over stopping at Top? It seems to me that using Top Arc and Straight Line Delivery Path is more complicated than just the Straight Line path available if one stopped at Top.
I recall there is a comment by Yoda in one of the videos that he goes to End when Swinging to differentiate the feelings between Swinging and Hitting. However, if one is primarily or only a Swinger, is there another advantage to going to End?
The difference is so you can load the lag pressure against the first knuckle by going to the end of the backstroke ready to drag that pressure by the pivot. The hitter loads directly against pp3, ready to drive directly by the thrusting of hit right triceps.
I don't have the book at hand for reference (shame!) but I believe 12-2 recommends Assembly point for Swingers as End. What advantages are offered over stopping at Top? It seems to me that using Top Arc and Straight Line Delivery Path is more complicated than just the Straight Line path available if one stopped at Top.
I recall there is a comment by Yoda in one of the videos that he goes to End when Swinging to differentiate the feelings between Swinging and Hitting. However, if one is primarily or only a Swinger, is there another advantage to going to End?
TIA
RT
If anything, going to the End position necessitates that the hands have to go back to the right shoulder before going down plane together - an extra move - top arc and straight line.
From a Top position all that is needed is a straight line delivery.
The less you do in the golf swing, the better. Less is more, more is less.
In 7-9, 10-9-B, Impact address is mentioned as "useful" for hitters, yet in 12-1-0, why is standard address listed?
In 12-2-0, why is it a snap load then a non-auto sweep release? Should they not be the same as in snap with snap or sweep with sweep?
Justin,
1. The Standard Address for Hitters (12-1-0) is used for two reasons. First, it facilitates moving between the Hitting and Swinging (12-2-0) Basic Patterns. Second, it facilitates the Hitter's Angle of Approach procedure because the Right Forearm and the Shaft are pointing at nearly the same place on the Delivery Line. A Fix alignment of the Right Forearm (pointing at a 10-5-E Delivery Line) is really 'out of whack' with the Target Line, and this makes the alignment difficult for beginning Hitters. Nevertheless, Homer Kelley felt that ultimately, in the hands of the Hitting Master, the Impact Address position was preferred.
2. Remember, no matter what Release Type and Release Point are employed, the Swinger's Snap Load overcomes the initial inertia of the Clubhead at the Top and Loads the Lag. And it is done by the Pivot, not the Hands. This 'Instant Acceleration' (10-19-C) is very desirable for the Swinger and sets up the entire Centrifugal Downstroke Release Sequence (6-M-1). Longer term, the Swinger will almost certainly customize the Pattern to incorporate first, the Non-Automatic Snap Release and later, the Automatic Snap Release. The Non-Auto Sweep variation is listed in the Basic Pattern as the first step -- maximum conscious control -- on the road to mastery of the more sophisticated Snap Releases.
1. The Standard Address for Hitters (12-1-0) is used for two reasons. First, it facilitate moving between the Hitting and Swinging (12-2-0) Basic Patterns. Second, it facilitates the Hitter's Angle of Approach procedure because the Right Forearm and the Shaft are pointing at nearly the same place on the Delivery Line. A Fix alignment of the Right Forearm (pointing at a 10-5-E Delivery Line) is really 'out of whack' with the Target Line, and this makes the alignment difficult for beginning Hitters. Nevertheless, Homer Kelley felt that ultimately, in the hands of the Hitting Master, the Impact Address position was preferred.
2. Remember, no matter what Release Type and Release Point are employed, the Swinger's Snap Load overcomes the initial inertia of the Clubhead at the Top and Loads the Lag. And it is done by the Pivot, not the Hands. This 'Instant Acceleration' (10-19-C) is very desirable for the Swinger and sets up the entire Centrifugal Downstroke Release Sequence (6-M-1). Longer term, the Swinger will almost certainly customize the Pattern to incorporate first, the Non-Automatic Snap Release and later, the Automatic Snap Release. The Non-Auto Sweep variation is listed in the Basic Pattern as the first step -- maximum conscious control -- on the road to mastery of the more sophisticated Snap Releases.
Great stuff there...I was always under the impression that 12-1-0 and 12-2-0 was the standard to "attain" to. New perspective there!! Major fog lifting...now I see what Mr Kelly meant by not customizing until expert stage is reached.
Hybrid Mode
